Infrared Sauna ,inspection checklist ,testing,quality assurance ,China inspectors QC report , malfunction ,Connection of sensor cables

You should not install sensor and power supply lines together, or lead them through the same feedthrough. This can lead to interferences in the electronics, such as “! uttering” in the relays. Connect the cable shielding (if present) to ground in the control unit. Please observe that the following dimensions relate to the values stipulated during the unit inspection acc. EN 60335-2-53. The heater sensor must always be installed at the point where the highest temperatures are to be expected. Fig. 12-14 provide you an overview of the mounting point of the sensor. 1. Mount the heater sensor in cabins up to 2 x 2 m according to ” g. 13, in larger cabins according to ” g. 14. 2. Drill a hole to lead the cable through, preferably through the middle of one of the wooden planks. Fig. 12 Fig. 13 Fig. 14 Installation of the temperature sensor

About author View all posts

admin

Leave a Reply

Your email address will not be published. Required fields are marked *